MAX5839的技术资料

The MAX5839 contains eight 13-bit, voltage-output digital-to-analog converters (DACs). On-chip precision output amplifiers provide the voltage outputs. The device operates from +14V/-9V supplies. Its bipolar output voltage swing ranges from +9V to -4V and is achieved
with no external components. The MAX5839 has three pairs of differential reference inputs; two of these pairs are connected to two DACs each, and a third pair is connected to four DACs. The references are independently controlled, providing different full-scale output voltages to the respective DACs. The MAX5839 operates within the following voltage ranges: V_DD = +7V to+14V, V_SS = -5V to -9V, and V_CC = +4.75V to +5.25V.

The MAX5839 features double-buffered interface logic with a 13-bit parallel data bus. Each DAC has an input latch and a DAC latch. Data in the DAC latch sets the output voltage. The eight input latches are addressed with three address lines. Data is loaded to the input latch with a single write instruction. An asynchronous load input (LD ) transfers data from the input latch to the DAC latch. The LD  input controls all DACs; therefore, all DACs can be updated simultaneously by asserting the LD  pin.

An asynchronous CLR  input sets the output of all eight DACs to the respective DUTGND input of the op amp.Note that CLR  is a CMOS input, which is powered by V_DD. All other logic inputs are TTL/CMOS compatible.

The “A” grade of the MAX5839 has a maximum INL of±2LSBs, while the “B” grade has a maximum INL of±4LSBs. Both grades are available in 44-pin MQFP packages.